Louver Lovers
4 1/2" Wide • 1 9/16" Tall Vent Slat (1/4" pegs)
4 1/2" Wide • 1 9/16" Tall Vent Slat (1/4" pegs)
Share
Couldn't load pickup availability
Buy More and Save - Combines with Other Sizes
Buy | Save |
---|---|
3 or more | 13% off |
6 or more | 18% off |
9 or more | 25% off |
Bulk Savings Are Available! Contact Us To Find Out More!
Compatible with select Dundas Jafine louvered vents.
This 4 1/2" wide slat features a 3/32" peg along the top edge, extending 1/4" beyond each side of the slat.
The Absolute Measurements Are:
• 5" Total Width (pegs included)
• 4 1/2" Slat Width (without pegs)
• 1 9/16" Height
• 1/4" Peg Length
• 3/32" Peg Diameter
• 1/16" Slat Thickness
Manufactured via fusion deposition modeling, this slat is produced using ASA plastic, which can be sanded and painted to match existing installation










fits perfectly , easy to install
website easy to order
The old louvers on our dryer vent had bowed over the years, to the point that they wouldn’t open and close and they easily fell out. Was going to replace the entire dryer vent but realized that the screws to the old one are cemented into the brick of our house. After lots of googling I finally figured out that the louvers could just be replaced and found louverlovers.com Ordered them on a Friday and they arrived on Monday. They are a perfect fit! Thank you!
Slats were delivered very quickly as described. Very satisfied with the product. Will order again in the the near future
4 1/2" Wide • 1 9/16" Tall Vent Slat (1/4" pegs)
Fit perfectly